AC Hipot Tester:AN9601H(F)

Sum Mary :

Download :

Product Info：

Main features

◆Compliant with IEC60335,GB4706,GB7000.1-2002 standard requirements;

◆Large blue LCD display, with key parameters display in large font size;

◆Slow Rise/Fall, scanner and test ,test line clear to zero function;

◆Upper and lower limit alarm, open and short circuit alarm protection;

◆Intelligent judgment, voice and light alarm, large font display;

◆8-group and 8-step test condition memory;

◆Advanced PWM control and DSP technical;

◆High accuracy, High efficiency, large capacity, small volume.

Technical Parameters

Model		AN9601H(F)
Output Characteristics	Rated Output	200VA(AC:5KV/40mA)
	Output Voltage Range	AC:100V~5000V
	Step Size	1V/step
	Output Voltage Accuracy	±(2% of setting+5V)
	Output Frequency Range	50Hz / 60Hz (optional) ±100ppM
	Output Frequency Accuracy	±0.1%
	Output Voltage Waveform	Sine wave
	Output Voltage Distortion Rate	200V or above: <2% 100V~200V: <5%(pure resistance load)
	Voltage Regulated Rate	±(2% of setting+5V)
	Output Mode	Sinusoidal pulse width modulation (SPWM)
Parameters Test	Voltage Resolution	10V
	Voltage Measurement Accuracy	±(2% of reading+5V)
	Leakage Current Meas. Range	AC:0.000~3.500mA/3.50~40.00mA
	Leakage Current Resolution	0.001mA/0.01mA
	Leakage Current Accuracy	±(2% of reading+3counts) (0.2mA above) ±(2% of reading+10counts) (0.2mA below)
Alarm Setting	Upper Limit Setting Range	0.00~40.00mA
	Lower Limit Setting Range	0.000~9.999mA
	Step Size	Upper limit: 0.01mA/step, Lower limit: 0.001mA/step
	Accuracy	±(2% of reading+3counts) (0.2mA above) ±(2% of reading+10counts) (0.2mA below)
Test time Setting	Dwell time	0.5~999.9s or continuous test
	Ramp-up time	0.0~999.9s
	Ramp-down Time	0.0~999.9s
	Step Size	0.1s/step
Protection Function		Auto protection function
Display		LCD display
Interface		SCAN, RS232(RS485 optional) Printer On-Off signal interface: start and stop signal input, Load 1-8 groups, Pass, Fail, Testing, Error signal output.
Dimension (W×H×D) (mm)		400×156×475